Posted on 24th Jun 2011 @ 6:13 AM
700R4 Transmissions have 3 Speed-o-meter Gear Types: Compare the three photos to the gear set on your original transmission.
Place punch behind metal gear and drive gear down shaft (off)
CAREFUL not to damage gear. must reinstall gear on new transmission. hammer gear down shaft until gear covers both holes on output shaft.
2) Mechanical Nylon / Digital Gear set information converted to digital signal.
To remove the nylon drive gear from original transmission. Depress metal clip and tap nylon gear towards the rear of the output shaft.
- Re-install gear the reverse way on new transmission.
- Install metal clip in the front hole in output shaft,
- Slip drive gear down shaft until clip lock gear into place. Install Driven gear and housing into tail housing.
3) Mechanical = Mechanical Nylon Gear set information set via mechanical cable.
Remove and Install the Gear set as shown.
Drive Gear = Gear on output shaft
Driven Gear = Gear that is installed into Tail Housing.
If you have any questions please contact our Tech Support Team at (800) 708-0087 ext. 2